Non-Residential Electric Service Application Your browser does not have JavaScript capabilities enabled. This page (and other pages on this site) may not work as designed. It is highly recommended that you enable JavaScript and reload this page for optimum usability and experience. All required fields are marked with *This form could not be completed. Please review the highlighted messages below. This form is for New Non-Residential Construction Meter Installation. You can find the Residential form here. Service Address*Address:*City:State:WI*ZIP Code:*Municipality:Select One...City of KaukaunaTown of BuchananTown of FreedomTown of HollandTown of KaukaunaTown of OneidaTown of VandenbroekVillage of Combined LocksVillage of Little ChuteVillage of WrightstownOther...MUNICIPAL PERMIT REQUIRED IN ALL CASES*Municipality Name:*Type of Service:Select One...AgriculturalApartment BuildingCommercialIndustrialMunicipalSeasonalTemporary (See utility for cost)Other...*Type of Service:*# of Units:Responsible Party for Monthly Utility Bills*Business Name:*Full Name:*Primary Phone #:Alternate Phone #:*Email Address:*Billing Address:*Billing City:*Billing State:*Billing ZIP Code:Electrician / Builder Information*Name:Full Name or Business Name*Phone #:Service Information*Type of Service: Overhead (400 Amp or Less) Underground*Type of Service: 120/240 1-Ph 3W (400 Amp or Less) 120/208 3-Ph 4W Y 277/480 3-Ph 4W Y Greater than 480 V (Call Utility) The following fields are all optional. Please complete them to the best of your ability. Service Size:100 to 1600 AmpsService Cable MCM:(if > 400 Amps)Service Cable Type: Copper (Cu) Aluminum (Al) Compressed Aluminum (Comp A)# of Parallel Runs:Calculated Load:kVAAnticipated Diversity:%Square Footage of Building Served:Sq. Ft.AC Unit Size:TonsType of Heating:Heating Unit's Output:BTUList All Motors:Include what it will be used for, HP, locked-rotor current, & voltage.See utility service rules for soft-start requirements and rural limitations. The following checklist must be completed before the utility will process this application: *Checklist:Each item must be completed Contact Utility to discuss new service (Engineering Tech's # (920) 462-0222 or Manager of Elect. Dist. # (920) 462-0214) Application card filled out by owner/electrician/builder/consultant engineer Address posted (temporary posting permitted until permanent sign can be placed) Submit completed application (see below)Acknowledgment & Signature*Applicant's Name:*Email Address:The signer's name above is required before signing.*Acceptance: I confirm the information above is accurate and checklist items are complete.Signature: Processing...
